Bissell 1672 SERIES User Manual page 10

How To Clean Bare Floors
Getting Ready
Attach bare floor attachment to bottom of floor nozzle
1.
with rubber and brush strips facing out. Align front edges
and snap together.
Fill measuring lid twice with Bissell Floor Care and empty
2.
into filling cavity.
Pour two gallons of hot tap water into filling cavity.
3.
Water level should reach the bottom of three vertical
lines in tank unit.
Cleaning
Turn vacuum/suction and pump/spray switches on.
1.
Depress trigger and pull floor nozzle toward you.
2.
Release trigger and repeat action to extract excess moisture.
3.
Disconnect bare floor attachment. Turn off machine, hold
4.
floor nozzle away from you, push bare floor tool off with
thumbs.
See WHEN YOU'RE DONE, page 9 and PUTTING IT AWAY,
5.
page 12.
How To Dry Vacuum
Make sure tank unit is dry before proceeding.
1.
Check motor filter. Clean if necessary.
2.
Pull dry filter bag over ball cage, catching edge of bag
3.
over lip at bottom of cage.
Place ball on raised area at bottom of tank unit.
4.
Position ball cage over ball and press firmly onto
5.
raised area.
Remove two small aluminum wand clips and floor nozzle
6.
from wand.
10
Vacuum/suction switch
Pump/spray switch
Tip:
To clean bare floors, attach
Bare Floor Attachment to
bottom of Floor Nozzle with
the rubber and brush strips
facing out. Align front edges
Floor Nozzle
Bare Floor
Attachment