Putting The Unit Back Together - Bissell PROHEAT PRO-TECH #1699 Repair Manual

B
issell PowerSteamer® ProHeat™ Series Service Center Repair Guide

PUTTING THE UNIT BACK TOGETHER

1. Follow the assembly diagram to ensure that all parts are replaced properly.
SEE PAGE 18
2. Make sure the foot pedal is in the proper position.
3. The SmartMix should be properly loaded into the main housing. This is done by first
turning the SmartMix knob to the "water only" setting, placing the SmartMix piston in
place, then turning the SmartMix knob to the "heavy traffic" setting.
4. Make sure the gasket around the nozzle is in place by guiding it into the slot with your
finger or screwdriver.
5. Make sure the cover is reassembled so that it is directly above the base before lowering it
into position.
6. Turn the diverter valve to "tools" setting. Lift diverter door lightly and check to ensure
that the upholstery duct is aligned to the oval hole in the housing. Press diverter door
back down and return valve to "floor" setting. Some models require that the front housing
be snapped back onto the base. Do this by pushing down on the front of the housing.
Printed February, 2001
1/30/2004 (Revision 1)
13