Table of Contents
Advertisement
Bits per second
Use this item to select serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower speeds.
The optional settings are: [9600]; [19200]; [57600]; [115200].
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a "stop" signal can be sent to stop the data flow.
Once the buffers are empty, a "start" signal can be sent to re-start the flow.
Hardware flow control uses two wires to send start/stop signals.
The optional settings are: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
4 PC Health Status
Press [Enter] to set shutdown temperature or view current hardware health status.
Shutdown Temperature
Use this item to select system shutdown temperature.
The optional settings are: [Disabled];[70
o
o
[85
C/185
F]; [90
4 CPU Configuration
Press [Enter] to view current CPU configuration and make settings for the following
sub-items:
Limit CPUID Maximum
The optional settings: [Disabled]; [Enabled].
o
o
C/194
F].
o
o
C/158
F]; [75
24
o
o
o
C/167
F]; [80
C/176
o
F];
Advertisement
Table of Contents
