Table of Contents
Advertisement
The optional settings are: [Do not launch]; [UEFI]; [Legacy].
4 Wake-up Function Settings
Press [Enter] to make settings for the following sub-items:
Wake-up System with Fixed Time
Use this item to enable or disable system wake-up by RTC alarm.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the hour/min/sec specified.
Wake-up System with Dynamic Time
Use this item to enable or disable system wake-up by RTC alarm.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will wake on the current time + increased
minute(s).The settings range is from [1] ~ [60] minute(s).
USB Wake-up from S3-S4
Use this item to enable or disable USB Wake-up from S3-S4 state.
The optional settings: [Disabled]; [Enabled].
*Note: This item is only supported when 'ERP Support' is set as [Disabled].
Please disable ERP before activating this function in S4 state.
4 USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
Legacy USB Support
The optional settings are: [Enabled]; [Disabled]; [Auto].
[Enabled]: To enable legacy USB support.
[Disabled]: To keep USB devices available only for EFI specification,
[Auto]: To disable legacy support if no USB devices are connected.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
The optional settings are: [Disabled]; [Enabled].
27
Advertisement
Table of Contents
