Table of Contents
Advertisement
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
The optional settings are: [Auto]; [IO=3F8h; IRQ=4]; [IO=2F8h; IRQ=3]; [IO=3E8h;
IRQ=4]; [IO=2F8h; IRQ=3].
ERP Support
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled] if you wish to have all active wake-up
functions.
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if Pin (4-5) of AT_COPEN has been
short or not (refer to Page 9); if these two pins short, system will show Case Open
Message during POST.
WatchDog Reset Timer
Use this item to enable or disable WatchDog Timer reset function. When set as
[Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [10] to [255] when 'WatchDog Reset Timer
Unit' is set as [Sec.], or [1] to [255] when 'WatchDog Reset Timer Unit' is set as
[Min.].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
WatchDog Wake-up Timer
This item support WDT wake-up while ERP function is set as [Enabled].
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Wake-up Timer Value
The setting range is [10] ~ [4095] seconds, or [1] ~ [4095] minutes.
20
Advertisement
Table of Contents
