ActionTec WNS100 User Manual page 57

Actiontec Wireless Network Attached Storage Device User Manual
Problem 2:
Solution 2
The Device is configured, but I can't find it in Network
NAS
Neighborhood.
Try using Start - Find - Computer, and enter the
Device's name. If this does not work, use Control Panel -
Network to check the following:
protocol is installed. If not, use Add - Protocol
•
TCP/IP
- Microsoft - TCP/IP to install it.
• Check the network Bindings:
• Ensure the
card ( ).
NIC
Select the Network card, click Properties, and then the
Bindings tab. If
it.
• Ensure the
the Client for Microsoft Networks service.
Select the
TCP/IP
Properties, and then the Bindings tab. If Client for
Microsoft Networks is not bound (checked), check it.
• If you don't have a router, check that the
compatible with the
to be from the same address range (e.g. 192.168.0.1 to
192.168.0.254) and using the same subnet mask (e.g.
255.255.255.0)
• If you do have a router, check that the gateway
address is set correctly. Ask the administrator for the
correct value.
protocol is bound to the Network
TCP/IP
is not bound (checked), check
TCP/IP
-> Network card entry is bound to
TCP/IP
entry for the Network Card, click
Device's. This means it needs
NAS
54
NAS
address is
IP
IP