Table of Contents
Advertisement
Troubleshooting
This chapter lists some common problems, and their solutions.
Problem 1:
Solution 1:
The NAS Utility doesn't list any NAS Devices.
Check the following:
• The
Device is installed,
NAS
and it is powered on and startup is complete.
• Ensure the computer and the
same network segment. (If you don't have a router,
this must be the case.)
• Ensure the computer has the
loaded. In Windows, this is done by using Control
Panel-Network. If an entry for
is not listed, use Add - Protocol - Microsoft - TCP/IP
to add it.
You then need to select the new entry (
Network card), click Properties, and configure the
Address tab.
• If the
LAN
an
Address automatically".
IP
• Otherwise, you must select "Specify an
and enter values for
Remember that each device needs a unique
and the same subnet mask.
LAN
has a
server, you can select "Obtain
DHCP
address and subnet mask.
IP
53
6
connections are
Device are on the
NAS
network protocol
TCP/IP
-> Network card
TCP/IP
->
TCP/IP
Address,"
IP
address,
IP
,
OK
IP
Advertisement
Table of Contents
