Table of Contents
Advertisement
REPLACEMENT AND ADJUSTMENT
10.13 INVERTER ROLLER REPLACEMENT
[B]
[A]
[G]
1. Remove the paper feed-out unit. (Refer to Feed-Out Unit removal.)
2. Remove the inverter guide plate [A] (1 screw and 2 springs [B]).
3. Remove the inverter motor assembly [C] (3 screws and 1 E-ring) and the
timing belt [D].
NOTE: Be careful not to lose pin [E].
4. Remove the bushing [F] (1 E-ring), inverter roller sprocket [G] (1 E-ring),
and bushing [H].
5. Replace the inverter roller and the inverter roller shaft.
[C]
[B]
[E]
[H]
42
12 February 1992
[D]
[F]
Advertisement
Table of Contents
