Replacement And Adjustment; Transport Belt Removal - Ricoh DF56 Service Manual

REPLACEMENT AND ADJUSTMENT

10. REPLACEMENT AND ADJUSTMENT

10.1 TRANSPORT BELT REMOVAL

[A]
1. Shut down the power, then remove the DF stopper [A] (2 screws) and
stand the DF 90
2. Remove the inner cover [B] (2 screws), hinge [C] (1 stud screw and 3
screws), and switch cover [D] (1 screw and 1 connector)
3. Open the paper feed unit [E]. Then remove the transport belt unit [F] (5
screws).
4. Remove the 2 springs, then remove the transport belt. [G].
NOTE: The DF belt has to be installed in the notch [H] as shown.
[E]
o
on end.
[C]
[B]
[F]
[D]
[H]
30
12 February 1992
[G]