Table of Contents
Advertisement
MDS-NT1
Note: Follow the disassembly procedure in the numerical order given.
3-2.
CASE (UPPER)
wire (flat type) (7core)
1 three screws
(BVTP3
10)
Note 2: Check that the lead wire is connected vertically to the chassis
before installing the upper case.
If the lead wire is not connected vertically, it may be caught
between the upper case.
lead wire
OK
14
Note 1: Fold down the flat type wire (7 core) in the direction of the
arrow at the first setout, then install the upper case.
2 case (upper)
chassis
lead wire
NG
lead wire
chassis
wire (flat type) (7 core)
1 three screws
(BVTP3
10)
Advertisement
Table of Contents
