6: Preparing The Receiver And The Remote - Sony HT-DDW5500 Operating Instructions Manual

6: Preparing the receiver
and the remote
Setting the voltage selector
If your receiver and power amplifier has a
voltage selector on the rear panel, check that
the voltage selector is set to the local power
supply voltage. If not, use a screwdriver to set
the selector to the correct position before
connecting the AC power cord to a wall outlet.
Depending on the models of area code, the
VOLTAGE SELECTOR may differ.
Receiver
VOLTAGE
SELECTOR
Power amplifier
b)
120V 220V
VOLTAGE SELECTOR
a)
For the models of area code EA: 230 - 240V
b)
For the models of area code EA: 120 - 127V
a)
240V
220V
b)
120V
a)
240V
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
AC power cord
FRONT
L
R
To the wall outlet
29 GB