5: Preparing The Receiver And The Remote - Sony HT-DDW880 Operating Instructions Manual

5: Preparing the receiver
and the remote
Setting the voltage selector
If your receiver has a voltage selector on the
rear panel, check that the voltage selector is set
to the local power supply voltage. If not, use a
screwdriver to set the selector to the correct
position before connecting the AC power cord
to a wall outlet.
VOLTAGE
SELECTOR
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
AC power cord
CENTER
+ –
SURROUND BACK
L
+ –
R
FRONT A
S
SPEAKERS
To the wall outlet
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
120V
220V
240V
R L
R L
FRONT B
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2
?/1
SPEAKERS
(OFF/A/B/A+B)
AUTO CAL MIC
MEMORY/ TUNING
ENTER MODE TUNING
VIDEO 3 IN/PORTABLE AV IN
PHONES
VIDEO L AUDIO R
3
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
"PUSH" and "ENTER" appears on the
display alternately.
3
Press MEMORY/ENTER.
After "CLEARING" appears on the
display for a while, "CLEARED"
appears.
The following items are reset to their
factory settings.
• All settings in the LEVEL, TONE,
SUR, TUNER, AUDIO, VIDEO and
SYSTEM menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• All index names for inputs and preset
stations.
• MASTER VOLUME is set to "VOL
MIN".
• Input is set to "DVD".
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
2CH A.F.D. MOVIE MUSIC MULTI CH IN MUTING
29
GB