Naming Preset Stations - Sony HT-DDW5500 Operating Instructions Manual

4
Press the numeric buttons to
select a preset number.
You can also press PRESET + or
PRESET – repeatedly to select a preset
number.
If "MEM" goes out before you select the
preset number, start again from step 3.
5
Press ENTER.
The station is stored as the selected preset
number.
If "MEM" goes out before you press
ENTER, start again from step 3.
6
Repeat steps 1 to 5 to preset
another station.
Tuning to preset stations
1
Press TUNER repeatedly to
select the FM or AM band.
2
Press PRESET + or PRESET –
repeatedly to select the preset
station you want.
Each time you press the button, you can
select a preset station as follows:
1 2 3
30
You can also press the numeric buttons to
select the preset station you want. Then,
press ENTER to enter the selection.
58
GB
4 5 ... 27
29 28

Naming preset stations

1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Tune in the preset station you
want to create an index name
for (page 58).
3
Press AMP MENU.
"1-LEVEL" appears on the display.
4
Press V/v repeatedly to select
"4-TUNER".
5
or b to enter the
Press
menu.
6
Press V/v repeatedly to select
"NAME IN".
7
or b to enter the
Press
parameter.
The cursor flashes and you can select a
character.
8
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
9
Press .
The name you entered is registered.