Programming - tams elektronik FD-R Extended Series Manual

English

7. Programming

Programming with DCC central units
You can programm the configuration variables (CV) of the decoder from
the digital central unit, you can use main track programming as well.
See the chapter in the manual of your central unit where the byte wise
programming of configuration variables (CVs) (Direct programming)
and main track programming (POM) are explained. With central units
that allow only register-programming it is not possible to program the
FD-R Extended.
Please note: In DCC-Format the feedback signal will not be sent by the
central unit unless there is a sufficient current. For that reason you
should mount an accessory with a current consumption of minimum
100 mA to one of the outputs before starting to program the function
decoder.
Programming with Motorola central units
In Motorola format the settings are saved in registers.
Please note: If you use a central unit for both DCC and Motorola format
it is recommended to program the decoder in the DCC format. After
having finished programming the decoder it is possible to control it in
Motorola format as well.
Please note: You should connect a lamp or a LED to at least AUX1 or
AUX2 before starting to program the decoder with a Motorola central
unit, as the decoder shows the status of the programming by flashing
the lighting connected to the outputs AUX1 and AUX 2. The flashing
frequency shows, which input the decoder expects:
Slow flashing
Number of the register to be
programmed
Page 30
Fast flashing
Value of the register to be
programmed
FD-R Extended