Automated Processes - tams elektronik FD-R Extended Series Manual

English
Mapping of the outputs to the function keys
The mapping of the outputs to the function keys and the switching
inputs is arbritary. It is possible to assign several function keys and
switching inputs to one output.
Output
AUX1 to AUX6
All function outputs can be switched inverted, i.e. when set to position
"on" the assigned function output will be switched off, when set to
position "off" switched on.

4.5. Automated processes

The control software in the function decoder allows you to automate
procedures and to reduce complex processes to one keystroke.
Dimming depending on the velocity
You can automatically switch functions depending on the velocity when
reaching a speed level defined in a CV. You assign an individual voltage
to the function outputs for the ranges of speed levels underneath and
above the defined speed level. This allows for example to switch on and
off the high beam light, to control the cab light or to influence the
intensity of the steam output.
Special function for speed level 0
By programming the special function for speed level 0 you can switch
on or off several function outputs and functions at the same time, you
otherwise had to switch singularly. This allows e.g. to switch off several
lights at once when parking a locomotive in the depot (e.g. front and
back lights, cab light and undercarriage light).
Page 14
DCC format
F0 to F28
FD-R Extended
MM format
F0 to F4 or
F5 to F9
(= F0 to F4 of a
2nd decoder address)