E-Heater Setting - York DWCPXY Owner's Manual

Wired Zone Controller DWCPXY

3.9 E-heater Setting

E-heater (auxiliary electric heating function): In the Heating mode, E-heater can be turned on for
improved efficiency.
Once the wired zone controller or the remote controller enters the Heating mode, this function will
turn on automatically.
Press "Function" in the Heating mode to enter the E-heater setting interface. Then press
"Enter/Cancel" to cancel this function.
Press "Function" to enter the E-heater setting status if the E-heater function is not activated. Then
press "Enter/Cancel: to activate it.
The setting of this function is shown in Fig.3.9.1 below.
Press Function repeatedly until
reaching the Turbo function status.
Fig.3.8.1 Turbo Setting
10
Press Function repeatedly until reaching
the Turbo function status again.