Operation Instructions; On/Off; Mode Setting; Temperature Setting - York DWCPXY Owner's Manual

Wired Zone Controller DWCPXY
▲+▼
2+6
(Lock)

3 Operation Instructions

3.1 On/Off

Press On/Off to turn ON the unit and turn it OFF by pressing the button again.
Note: Fig.3.1.1 indicates the "Off" state of the unit after applying power. Fig.3.1.2 indicates the
"On" state of the unit after applying power.
Fig.3.1.1 "Off" State

3.2 Mode Setting

Under the "On" state of the unit, press the Mode button to switch the operation modes as in the
following sequence: Auto–Cooling–Dry–Fan–Heating.

3.3 Temperature Setting

Press ▲or ▼ to increase/decrease the preset temperature. If pressing either of them
continuously, the temperature will be increased or decreased by 1°F every 0.5 second, as shown
in Fig.3.3.1. below
In the Cooling, Dry, Fan or Heating mode, the temperature setting range is 60.8°F to 86°F
(16°Cto 30°C).
In the Auto mode, the setting temperature is not adjustable.
Upon start-up of a unit that had no malfunction or when the unit is
OFF, press them at the same time for five seconds to enter a lock
state. In this instance, no other buttons will respond if pressed. Press
them again for five seconds to discontinue this condition.
Fig.3.1.2 "On" State
4