Avaya G450 Media Gateway Provisioning - Avaya Aura Communication Manager 7.1 Application Notes

6.14. Avaya G450 Media Gateway Provisioning

In the reference configuration, a G450 Media Gateway is provisioned. The G450 is located in the
Main site and is used for local DSP resources, announcements, Music On Hold, etc.
Note – Only the Media Gateway provisioning associated with the G450 registration to
Communication Manager is shown below. For additional information on G450 provisioning, see
[7].
Step 1 - Use SSH to connect to the G450 (not shown). Note that the Media Gateway prompt will
contain "???" if the Media Gateway is not registered to Communication Manager (e.g.,
G450-???(super)#).
Step 2 - Enter the show system command and copy down the G450 serial number (e.g.,
08IS38199678).
Step 3 - Enter the set mgc list x.x.x.x command where x.x.x.x is the IP address of the
Communication Manager Processor Ethernet (e.g., 10.64.91.65, see Section 6.4).
Step 4 - Enter the copy run start command to save the G450 configuration.
Step 5 - From Communication Manager SAT, enter add media-gateway x where x is an available
Media Gateway identifier (e.g., 1).
Step 6 - On the Media Gateway form (not shown), enter the following parameters:
 Set Type = g450
 Set Name = a descriptive name (e.g., G450-1)
 Set Serial Number = the serial number copied from Step 2 (e.g., 08IS38199678)
 Set the Link Encryption Type parameter as desired (any-ptls/tls was used in the reference
configuration)
 Set Network Region = 1
Wait a few minutes for the G450 to register to Communication Manager. When the Media
Gateway registers, the G450 SSH connection prompt will change to reflect the Media Gateway
Identifier assigned in Step 5 (e.g., G450-001(super)#).
DDT; Reviewed:
SPOC 10/18/2017
Solution & Interoperability Test Lab Application Notes
©2017 Avaya Inc. All Rights Reserved.
53 of 95
CM71SM71-VzIPCC