Table of Contents
Advertisement
Step 6: Preparing the
Remote
You can control the recorder using the supplied
remote. Insert two R6 (size AA) batteries by
matching the 3 and # ends on the batteries to the
markings inside the battery compartment. When
using the remote, point it at the remote sensor
on the recorder.
b
Notes
• If the supplied remote interferes your other Sony DVD
recorder or player, change the command mode number
for this recorder (page 24).
• Use the batteries correctly to avoid possible leakage
and corrosion. Do not touch the liquid with bare hands
should leakage occur. Observe the following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an extended
period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid inside
the battery compartment, and insert new batteries.
• Do not expose the remote sensor (marked
front panel) to strong light, such as direct sunlight or
lighting apparatus. The recorder may not respond to the
remote.
22
Controlling TVs with the remote
You can adjust the remote's signal to control your
TV.
If you connected the recorder to an AV amplifier
(receiver), you can use the supplied remote to
control the AV amplifier's (receiver's) volume.
b
Notes
• Depending on the connected unit, you may not be able
to control your TV or AV amplifier (receiver) with
some or all of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the code
number may be reset to the default setting. Set the
appropriate code number again.
Number
buttons, SET,
-/--
on the
1
Slide the TV/DVD switch to TV.
2
Hold down [/1.
3
Enter your TV's manufacturer code (see
"Code numbers of controllable TVs"
below) using the number buttons.
TV/DVD switch
[/1
t TV/DVD
1
2
3
PROG +/–
4
5
6
7
8
9
2 +/–
0
Hide quick links:
Advertisement
Table of Contents
