Toyota C-HR 2019 Quick Reference Manual page 30

TOYOTA SAFETY SENSE
LANE DEPARTURE ALERT (CONTINUED)
The LDA w/SA function
switched to the driving assist system information screen.
(1) The system displays solid white lines on the LDA indicator when visible lane
markers on the road are detected. A side flashes orange to alert the driver when the
vehicle deviates from its lane.
(2) The system displays outlines on the LDA indicator when lane markers on the
road are not detected or the function is temporarily cancelled.
Note: When operational conditions are no longer met, the function may be
temporarily canceled. However, when the operational conditions are met again,
operation of the function is automatically restored. For example, LDA w/SA
may not function on the side(s) where white/yellow lines are not detectable.
Refer to a Toyota Owner's Manual for additional information on LDA operation,
settings adjustments, limitations, and precautions before attempting to use it.
DISABLING STEERING ASSIST
(1) Press " " switches and select
(2) Press " " switches and select the
press " ".
(3) Press " " each time to change the setting.
(4) Press " " to go back to the menu.
Note: Operation of the LDA w/SA system and setting adjustments continues in
the same condition regardless of Ignition cycle until changed by the driver or
the system is reset.
ADJUSTING LDA ALERT SENSITIVITY
The driver can adjust the sensitivity of the LDA (warning) function from the
Multi-Information Display (MID) customization screen.
High - Is designed to warn approximately before the front tire crosses the
lane marker.
Normal - Is designed to warn approximately when the front tire crosses
the lane marker.
(1) Press " " switches and select
(2) Press " " switches and select the
" " to set sensitivity to Normal or High.
(3) Press " " each time to change the setting.
(4) Press " " to go back to the menu.
™
displays when the Multi-Information Display (MID) is
from the Multi-Information Display (MID).
Steering Assist function and then
from the Multi-Information Display (MID).
Alert function and then press
28