Checking Coolant Level; Adding Coolant - Mercedes-Benz 560 SL 107 1988 Owner's Manual

1 Coolant reservoir cap
2 Marking for coolant level

Checking Coolant Level

The coolant reservoir with filler
neck is arranged away from the
radiator. To check the coolant level
the vehicle must be parked on level
ground.
The coolant level must reach:
• the mark indicated on the reser­
voir when the coolant is cold
• approximately 2 cm (0.8 in)
higher when the coolant is hot.

Adding Coolant

If coolant has to be added, a 50/50
mixture of water and MB anticorro­
sion/antifreeze should be used.
Warning!
• Use extreme caution when
opening the hood, if there are
any signs of steam or coolant
leaking from the cooling sys­
tem.
• Do not remove pressure cap on
coolant reservoir if engine
temperature is above 90° C
(194° F). Allow engine to cool
down before removing cap. The
coolant reservoir contains hot
fluid and is under pressure.
• Using a rag, turn cap to first
notch to relieve excess pres­
sure. If opened immediately,
hot scalding fluid and steam
will be blown out under pres­
sure.
The drain plugs are located on the
right and left side of the engine and
on the radiator bottom.
71