Briggs & Stratton 130G00 Repair Manual page 72

8. See Figure 84. Apply pressure to bearing driver until
bearing is fully seated in bore.
9. Inspect the bearing for damage or distortion.
10. See Figure 85. Use your index finger to manually rotate
the bearing in both directions. Verify that bearing rotates
freely without roughness, sticking, or unusual noise.
11. With the outside facing upward, support crankcase
cover on wooden blocks on deck of arbor press.
NOTE: Do not install oil seal into crankcase cover if
engine is equipped with 2:1 or 6:1 gear reduction unit.
12. Apply a thin film of clean engine oil to oil seal bore and
OD of new oil seal.
13. Verify that oil seal lip garter spring is not broken or
missing.
14. Place oil seal into bearing bore.
15. Place suitable oil seal driver on outside edge of oil seal.
16. Center oil seal driver under ram.
84
6
66
85
17. See Figure 86. Slowly apply pressure to oil seal driver
until oil seal is at the depth shown below.
Models
130G00, 131G00, 13R200
13U100, 13U200
86
PTO Bearing Oil Seal Depth
0.157-0.177 in (4.0-4.5 mm)
0.118-0.130 in (3.0-3.3 mm)