Briggs & Stratton 130G00 Repair Manual page 46

42
5
1. See TOP END DISASSEMBLY in this section.
2. See Figure 43. Obtain Strap Wrench (Part No. 19433),
21 mm socket, and breaker bar. Proceed as follows:
NOTE: DO NOT use an air impact wrench to loosen
flywheel nut or thread damage may occur.
A. Fit loop of strap around flywheel and tighten until
snug.
B. Pinch strap between heel of wrench and flywheel
as shown.
C. Holding tool down by the handle, loosen flywheel
nut using breaker bar and 21 mm socket.
D. Remove strap wrench from flywheel.
40
BOTTOM END DISASSEMBLY
43
3. See Figure 42. Remove flywheel nut (A) from
4. Remove starter cup (B) and flywheel fan (C).
5. Remove flywheel (D) from crankshaft. Proceed as
crankshaft.
follows: