Unpacking And Inspecting A New Switch - Cisco Nexus 9396PX Hardware Installation Manual

Unpacking and Inspecting a New Switch

Unpacking and Inspecting a New Switch

Before you install a new chassis, you need to unpack and inspect it to be sure that you have all the items that
you ordered and verify that the switch was not damaged during shipment. If anything is damaged or missing,
contact your customer representative immediately.
Caution When you handle the chassis or its components, you must follow ESD protocol at all times to prevent
ESD damage. This protocol includes but is not limited to wearing an ESD wrist strap that you connect to
the earth ground.
Tip Do not discard the shipping container when you unpack the switch. Flatten the shipping cartons and store
them. If you need to move or ship the system in the future, you will need this container.
Step 1 Compare the shipment to the equipment list that is provided by your customer service representative and verify that you
have received all of the ordered items.
The shipment should include the following:
• Switch chassis, which includes the following installed components:
◦ Two power supplies
◦ Port-side intake airflow 650-W AC power supply (N9K-PAC-650W)
◦ Port-side exhaust airflow 650-W AC power supply (N9K-PAC-650W-B)
◦ Port-side intake airflow 930-W DC power supply (UCSC-PDU-930WDC)
◦ Three fan modules
◦ Port-side exhaust airflow (N9K-C9300-FAN2-B)
◦ Port-side intake airflow (N9K-C9300-FAN1) (previously shipped with the switch)
◦ Port-side exhaust airflow (N9K-C9300-FAN1-B) (previously shipped with the switch)
• Switch accessory kit
Step 2 Check the contents of the box for damage.
Step 3 If you notice any discrepancies or damage, send the following information to your customer service representative by
email:
• Invoice number of the shipper (see the packing slip)
• Model and serial number of the missing or damaged unit
• Description of the problem and how it affects the installation
Cisco Nexus 9396PX NX-OS-Mode Switch Hardware Installation Guide
14
Installing the Chassis