Cisco Nexus 9396PX Hardware Installation Manual page 12

Overview
The following figure shows the hardware features seen from the port side of the chassis.
Figure 1: Hardware Features on the Port Side of the Chassis
1 Console port (RS232 port)
2 Chassis LEDs
3 Two USB ports used for saving or copying
functions
Note
4 Out-of-band management port (RJ-45 port)
5 48 1- and 10-Gigabit Ethernet Small Form-Factor
Plugable (SFP+) optical ports (supporting
1-Gigabit and 10-Gigabit speeds) to switches or
Fabric Extenders (FEXs)
Cisco Nexus 9396PX NX-OS-Mode Switch Hardware Installation Guide
2
• Beacon (BCN)
• Status (STS)
• Environment (ENV)
USB support is limited to USB 2.0
devices that use less than 2.5 W (less
than 0.5 A inclusive of surge current).
Devices, such as external hard drives,
that instantaneously draw more than 0.5
A are not supported.
6 M6PQ or M12PQ uplink module (M12PQ uplink
module shown).
7 6 or 12 40-Gigabit Ethernet Quad Small
Form-Factor Pluggable (QSFP+) optical ports for
40-Gigabit connections to other devices (12-port
uplink module shown)
8 Notch in both sides of the chassis for locking the
power supply end of the chassis to the
bottom-support rails
9 Screw holes (4) for attaching a center-mount rack
bracket for two-post racks (one bracket for each
of two sides)
10 Screw holes (2) for attaching a front-mount
bracket for four-post racks (one bracket on each
of two sides)
Overview