Cisco Nexus 9396PX Hardware Installation Manual page 13

Overview
You can use the 1- and 10-Gigabit ports to connect this switch to up to 48 devices or to FEXs, which can be
connected to additional servers (for the number of FEXs that can be supported, see the release notes for the
NX-OS software that you are using). You can connect any of the following FEXs to the downlink ports:
• Cisco Nexus B22DELL-P FEX
• Cisco Nexus B22HP-P FEX
• Cisco Nexus 2248PQ-10GE
• Cisco Nexus 2248TP FEX
• Cisco Nexus 2248TP-E FEX
• Cisco Nexus 2232PP FEX
• Cisco Nexus 2232TM FEX
For installation information on the Cisco Nexus 2000 Series FEXs, see the Cisco Nexus 2000 Series Hardware
Installation Guide. For information on the Cisco Nexus B22-HP FEX, see the Cisco Nexus B22 Fabric
Extender for HP Getting Started Guide.
To determine which transceivers, adapters, and cables are supported by this switch, see the Cisco Nexus 9000
Series (Fixed 9300) at
products-device-support-tables-list.html.
The following figure shows the hardware features seen from the fan side of the chassis.
Figure 2: Hardware Features on the Power Supply Side of the Chassis
1 Screw holes (2) for attaching the grounding lug.
2 Notch in both sides of the chassis for locking the fan end of the
chassis to the bottom-support rails.
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/
Cisco Nexus 9396PX NX-OS-Mode Switch Hardware Installation Guide
Overview
5 Chassis LEDs are as follows:
• Beacon (BCN)
• Status (STS)
6 Screw holes (4) for attaching a
center-mount rack bracket for
two-post racks (one bracket for
each of two sides).
3