Settings For The Speakers (Speaker Setup) - Sony DVP-CX777ES Operating Instructions (DVD Player DVPCX777ES) Operating Instructions Manual

• 48kHz/96kHz PCM (DVD VIDEO only)
Selects the sampling frequency of the audio
signal.
48kHz/16bit The audio signals of DVD
VIDEOs are always converted
to 48kHz/16bit.
96kHz/24bit All types of signals including
96kHz/24bit are output in their
original format. However, if the
signal is encrypted for
copyright protection purposes,
the signal is only output as
48kHz/16bit.
Notes
• Even if you set "48kHz/96kHz PCM" to "96kHz/
24bit," the sampling frequency is converted to
48kHz/16bit when a "SURROUND" mode (page
70) is selected.
• The analog audio signals from the LINE OUT
AUDIO L/R jacks and 5.1CH OUTPUT jacks are
not affected by this setting and keep their original
sampling frequency level.
94
Settings for the Speakers
(SPEAKER SETUP)
To obtain the best possible surround sound,
input the size of the speakers you have
connected and their distance from your
listening position. Then use the test tone to
adjust the volume and balance of the speakers
to the same level.
This setting is effective when connecting a
speaker with 5.1 CH OUTPUT jacks (page
27).
You can create two different Speaker Setup
settings, one for Super Audio CDs and one for
all other types of discs.
1
Follow steps 1 through 4 of "Using
the setup display" (page 87) to
select "SPEAKER SETUP" in the
Setup display.
SPEAKER SETUP
DVD:
SUPER AUDIO CD:
2
Select "DVD" or "SUPER AUDIO
CD" using X/x, then press ENTER.
Example: when "DVD" is selected.
SPEAKER SETUP (DVD)
SIZE:
DISTANCE:
LEVEL(FRONT) :
LEVEL(REAR) :
TEST TONE:
FRONT:
CENTER:
REAR:
SUBWOOFER:
OFF
LARGE
LARGE
LARGE(REAR)
YES