Press the keys on the keypad as shown in the following steps. Wait for the confirmation indicator before proceeding to the next step. If
you make a mistake, wait for all lights and beeps to stop and then start over from the beginning.
Add
Delete
Change
Enable Vacation
Mode
(Disable All)
Enable/Disable
Beeper
Delete All
2
Enable/Disable
3
Turn Lock Feature
Put Lock in
Enrollment Mode
4
1
Enable All User Codes function is available only when user codes are currently disabled.
2
Delete All User Codes function will remove ALL user codes, but will not change the programming code. User Codes cannot be recovered after this function is completed.
3
The Turn Lock Feature is available only on the BE369 (deadbolt). When this feature is disabled, a valid user code must be entered in order to lock the lock from the
outside. The Turn Lock feature is enabled by default.
4
Bridge must be put into enrollment mode before lock for successful enrollment/exclusion.