Set The Basic Settings - JVC KD-R991BT Instruction Manual

GETTING STARTED
3

Set the basic settings

1
Press and hold .
2
Perform 'select an item ( 3 or 4)' operation to select an item
(see the following table).
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
SYSTEM
KEY BEEP (Not applicable when 3-way crossover is selected.)
ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
AM SRC *
ON: Enables AM in source selection. ; OFF: Disables. ( 7)
SW1 SRC *
ON: Enables SW1 in source selection. ; OFF: Disables. ( 7)
SW2 SRC *
ON: Enables SW2 in source selection. ; OFF: Disables. ( 7)
PANDORA SRC *
ON: Enables PANDORA in source selection. ; OFF: Disables. ( 11)
SPOTIFY SRC *
ON: Enables SPOTIFY in source selection. ; OFF: Disables. ( 12)
BUILT-IN AUX *
ON: Enables AUX in source selection. ; OFF: Disables. ( 13)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
* Not displayed when the corresponding source is selected.
6
ENGLISH
FACTORY RESET
CLOCK
TIME SYNC
CLOCK DISPLAY
.
ENGLISH
Default: XX
ESPANOL
YES: Resets the settings to default (except the stored station). ;
NO: Cancels.
ON: The clock time is automatically set using the Clock Time (CT) data
in FM Radio Data System signal. ; OFF: Cancels.
ON: The clock time is shown on the display even when the unit is
turned off. ; OFF: Cancels.
Select the display language for menu and music information if
applicable.
By default, ENGLISH is selected.