Bluetooth - JVC KD-R991BT Instruction Manual

BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Rear panel
Microphone (supplied)
Microphone input jack
Adjust the
Secure using cord clamps
microphone angle
(not supplied) if necessary.
14
ENGLISH
Pair and connect a Bluetooth device for the first time
1 Press source button to turn on the unit.
2 Search and select "KD-R9
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number
(PIN) code immediately after searching.
3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) KD-R991BT/KD-R891BT: "[Device Name]"
KD-R792BT: "[Device Name]"
"XXXXXX" is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the following operation to confirm the passkey.
KD-R991BT/KD-R891BT:
KD-R792BT:
Operate the Bluetooth device to confirm the passkey.
(B) KD-R991BT/KD-R891BT: "[Device Name]"
KD-R792BT: "[Device Name]"
Press the following to start pairing.
KD-R991BT/KD-R891BT:
KD-R792BT:
• If "PAIRING" "PIN 0000" scrolls on the display, enter the PIN code "0000" into the
Bluetooth device.
You can change to a desired PIN code before pairing. ( 19)
• If only "PAIRING" appears, operate the Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing is completed and " " will light up when the
Bluetooth connection is established.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if
you reset the unit. To delete the paired device,
BT"/"KD-R8 BT"/"KD-R7 BT" on the Bluetooth device.
"XXXXXX" "ENTER – YES"
"XXXXXX" "VOL – YES"
volume knob
"ENTER – YES"
"VOL – YES"
volume knob
19, [DEVICE DELETE].
"BACK – NO"
"BACK – NO"
"BACK – NO"
"BACK – NO"