Setup - Sharp PN-HM851 Software Setup Manual

Setup

 Continuous operating time and warranty. (PN-HB851/PN-HB751/PN-HB651 only)
This product is designed for a maximum daily use of 16 hours. Continual use in excess of 16
hours per day is not covered by the warranty.
 To maintain stable operation of the Android OS, restart the OS once a day. A SCHEDULE is set
by factory default in this monitor that restarts the OS at 3:00 AM. (To have the OS restart at a
specified time, refer to page 7.)
 In the factory default state, "POWER SAVE MODE" in the OSD menu is set to "OFF". When
"POWER SAVE MODE" is set to "OFF", Android™ OS continues to run even in the power "OFF"
(power standby) state.
 Make sure that data is not being written before switching off the main power switch. Risk of
equipment failure or data destruction if a power interruption occurs while data is being written.
 In Android, delayed writes are performed. If data is being written to a USB flash drive or SD
memory card, follow the procedure below to remove the device before switching off the main
power switch.
 A mouse or keyboard may be needed to perform procedures and configure settings in Android™.
Example: Operations using the status bar or the navigation bar
 It is recommended to use a USB keyboard or Bluetooth keyboard for entering text and symbols.
The numeric characters can be input by the numeric input buttons on the remote control.
[・]: Input a decimal point.
Text can be input by manipulating the software keyboard using the remote control.
 Note the following if you are using A USB flash drive or microSD memory card.
 Use a USB flash drive or microSD memory card that is formatted in "FAT32" or "NTFS" format.
File System
Capacity
 Media formatted in "exFAT" format cannot be used.
 Encrypted files and folders cannot be used.
 Do not use write protection or security functions.
 To remove a USB flash drive or microSD memory card, follow the procedure below. Risk of equipment
failure or data destruction if a memory device is removed without performing this procedure.
1. Press [CONTENT MENU] on the remote control to display the "CONTENT MENU" screen, and
select "File Explorer".
2. Select of the device you want to remove.
 Even in the following state, Android OS continues to run and the connected USB device and
Bluetooth device remains active. To stop the operation of the device, release the connection.
When "POWER SAVE MODE" is set to "OFF", and the power is tuned off (power standby)

When the input mode is set to a mode other than APPLICATION mode

FAT32/NTFS
Up to 64 GB
(Maximum file size for FAT32: 4 GB)
[CLEAR]: Delete a character.
1