Date & Time Tab; Current Date & Time; Sensor Input Mode; Time Zone - Sony SNC-RX530N User Manual

On: When you are tilting the camera downward using
the , or button on the control panel and the
camera reaches the point where it faces the ground, it
automatically pans 180 degrees and starts tilting
upward.
Off: When the camera tilts to the point where it faces the
ground, tilting stops.
Latency
Specify the time for which the camera movement stops
after it has tilted completely downward and before it
starts panning when Auto flip is set to On. This period
of time allows you to stop the camera movement without
panning.
Selectable values are 0 sec., 0.5 sec. are 0.75 sec..
Panorama mode
Select to rotate or not rotate the panorama image
displayed in the viewer in accordance with the pan
movement of the camera.
Rotate: The panorama image rotates as the camera
pans.
Fixed: The panorama image is fixed.

Sensor input mode

Specify the detection mode of the signal input to the
sensor input terminal of the camera.
Normally open: Detects alarm when the sensor input is
short-circuited.
Normally closed: Detects alarm when the sensor input
is open-circuited.
OK/Cancel
See "Buttons common to every menu" on page 30.
Date & time Tab
34
Configuring the System — System Menu
Current date & time
Displays the date and time set on the camera.
Note
After you have purchased the camera, be sure to check
the date and time of the camera and set them if
necessary.
PC clock
Displays the date and time set on your computer.
Date & time format
Select the format of date and time to be displayed in the
main viewer from the drop-down list.
You can select the format between yyyy-mm-dd
hh:mm:ss (year-month-day hour:minute:second), mm-
dd-yyyy hh:mm:ss (month-day-year
hour:minute:second), and dd-mm-yyyy hh:mm:ss
(day-month-year hour:minute:second).
Adjust
Select how to set the day and time.
Keep current setting: Select if you do not need to set
the date and time.
Synchronize with PC: Select if you want to
synchronize the camera's date and time with those of
the computer.
Manual setting: Select if you want to set the camera's
date and time manually.
Select the year, month, date, hour, minutes and
seconds from each drop-down list.
Synchronize with NTP: Select if you want to
synchronize the camera's date and time with those of
the time server called NTP server (Network Time
Protocol). Set the NTP server name and the
Interval.
NTP server name
Type the host name or IP address of the NTP server,
using up to 64 characters.
Interval
Select an interval between 1 and 24 hours at which you
want to adjust the camera's time referring to the NTP
server's time. The set interval is a guide, and does not
indicate the exact time.
Note
The setting time may not match with the exact time
according to the network environment.

Time zone

Set the time difference from Greenwich Mean Time in
the area where the camera is installed.
Select the time zone in the area where the camera is
installed from the drop-down list.