Changing The Test Setup - 3Com TokenLink Velocity 3C319 User Manual

9-6 C
HAPTER
5 Press [Enter] to start the tests.
Each test runs once unless you specify otherwise. The test
results are displayed on the screen with "Passed" or
"Failed" in the Results column.
To run the tests continuously, select the Continuous
option in the Test Setup dialog box, as described in the
next section,

Changing the Test Setup

To change the test parameters, follow these steps:
1 Select Test Setup in the Run Tests dialog box and
press [Enter].
The Test Setup dialog box appears, as shown in
Figure
Diagnostic and Manual Configuration Program Version 2.0
Quit Install
Group Select
Group 1
Group 2
Repetitions
(.) [1
Continuous
Errors
[X] Halt on Error
[ ]=Select a Test Group to View
[Alt]+<Highlighted Key>=Execute Function
[TAB]=Next Field [SHIFT+TAB]=Previous Field [F1]=Help [ESC]=<Cancel>
Figure 9-4 Test Setup Dialog Box
2 Press [Tab] to move from field to field and select
any field within the Test Setup dialog box.
Within the Group Select area, use the arrow keys to
select Group 1 or Group 2. Use the Enable Group or
Disable Group options to enable or disable a group
of tests.
9: T
ROUBLESHOOTING
"Changing the Test
9-4.
Test View Select
MMIO Register Write/Read Test
AIP Checksum Test
Shared RAM Boundary/Domain Test
Shared RAM Write/Read Test
Timer Test
Open NIC for Ring Operation Test
Ring Operations Test
Close NIC Test
]Times
Defaults
File Options...
NIC I
NSTALLATION
Setup."
Test Setup
Group 1 Tests
Enable Group
F1=Help
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
*Enabled
Disable Group
OK Cancel