3Com TokenLink Velocity 3C319 Quick Start

®
This Quick Start is for experienced token ring
network users. Perform the following steps to install
the 3Com
card (NIC) (3C319):
1 Install the 3C319 NIC in an ISA or EISA slot in
your PC.
2 Connect a token ring cable to the NIC.
3 Power on your PC.
The 3C319 NIC will be automatically configured in
a Plug and Play (PnP) PC.
settings in PnP and non-PnP PCs.
Table 1 Default Configuration Settings
Option
Plug and Play
Configuration Mode
I/O Base Address
Interrupt Request Level
Ring Speed
BIOS/MMIO Base Address
RAM Page Size
Shared RAM Address Range
Memory Mode
I/O Mode
IRQ Driver Type
AutoSwitch
Boot PROM
Zero Wait State
Q S
UICK TART FOR THE
T L
OKEN INK
ISA 3C319 N
I
NTERFACE
Part Number 09-0965-001/August 1997
® ®
TokenLink Velocity
Default Settings
in PCs with
PnP Support
Enabled
3Com
Set by PnP
Set by PnP
16 Mbps
Set by PnP
16 K
Set by PnP
16-bit
16-bit
Edge Triggered
Disabled
Disabled
Enabled
V
ELOCITY
ETWORK
C
ARD
™
network interface
Table 1 shows the default
Default Settings
in PCs without
PnP Support
Enabled
3Com
A20h
2(9)
16 Mbps
CC000
16 K
D8000–DBFFF
16-bit
16-bit
Edge Triggered
Disabled
Disabled
Enabled