Shifting Indicator Switch - BOMBARDIER RALLY 200 2003 Shop Manual

SHIFTING INDICATOR SWITCH

NOTE: The engine removal is not necessary to
reach the shifting indicator switches.
Removal
NOTE: Clean area from dirt before removing parts.
Remove screws retaining shifting indicator switch
wires.
Unscrew the shifting indicator switches no. 32.
1. Neutral switch
2. Reverse switch
3. Contact pin on switch
NOTE: Remove the shifting indicator switches
one at a time. It is recommended to use a socket
to removing an indicator switch.
VMR2003_014_03_10A.FM
Subsection 10 (GEARBOX)
Test
Check if shifting indicator switches work properly.
CAUTION: Switch pin has to move freely and
must not detach from its housing.
Check wiring harness and replace if brittle or hard.
Using a multimeter, measure the resistance of the
shifting indicator switches. Use the following pro-
cedure:
– Reinstall screw on each switch.
– Place one probe of multimeter on switch screw
and the other on the engine.
NOTE: The alligator clip is recommended.
Apply the end of switch on the engine.
If the resistance is infinite (O.L.), replace the shift-
ing indicator switch.
If the shifting indicator switch and its harness are
good, check the vehicle harness and/or indicator
lights.
Installation
For installation, reverse the removal procedure.
Pay attention to the following details.
If all switches are removed, take care to put back
wires at the proper location.
WIRES
YELLOW/GREY
VIOLET/GREY
Take care do not damage shifting indicator switch-
es threads during installation.
Section 03 ENGINE
SWITCH
Neutral
Reverse
03-10-15