Installing The Cylinder; Cylinder Installation Location Options - Weber Summit E-670 Owner's Manual

INSTALLING THE CYLINDER

Purchase a Full Cylinder of Gas From your Gas Dealer
The cylinder must always be installed, transported and stored in an upright position.
Never allow the cylinder to drop or be handled carelessly. Never store the cylinder where
temperatures can exceed 51° C (too hot to hold by hand). For example, do not leave the
cylinder in your car on hot days. (Refer to: "SAFE HANDLING TIPS FOR LIQUID PROPANE
GAS CYLINDERS").
Do not store an extra (spare) or disconnected gas supply cylinder
under or near this grill.
REQUIREMENTS FOR INSTALLATION
The maximum cylinder capacity is 13kg. For Customer's in Japan the maximum cylinder
capacity is 8 kg. The cylinder must be placed on the ground towards the rear, right hand
side of the grill. Do not attempt to install a cylinder inside the cabinet.
INSTALLATION ON GROUND
A) Place the cylinder on the ground, outside the base cabinet, on the right side of the grill
(1).
B) Turn the LPG cylinder so the opening of the valve is facing the front of the gas grill.
C) Connect the regulator to the cylinder. Refer to "CONNECTING THE LPG CYLINDER."
Note: The regulator illustrations shown in this manual may not be similar to the regulator you
are using for your grill, due to different country or regional regulations.
8
GAS INSTRUCTIONS
m DANGER
◆
7
The grills illustrated in this
Owner's Guide may vary slightly
from the model purchased.