Installing The Lpg Cylinder - Weber Spirit PREMIUM E-310 Owner's Manual

INSTALLING THE LPG CYLINDER

LPG cylinders may be acceptable for use provided they
are compatible with the appliance retention means (fuel
scale) .
The LPG cylinder is installed outside the cabinet, on the
fuel scale (right side panel) .
Prepare Barbecue for LPG Cylinder Installation
A) Check that all burner control knobs are in the off
( ) position . Your barbecue was shipped with control
knobs in the off ( ) position, but you should check
to be sure that they are turned off . Check by pushing
in and turning knobs clockwise . If they do not turn,
they are off . If they do turn, continue turning them
clockwise until they stop; then they are off . If your
barbecue has a side burner, make sure the side
burner control knob is turned off .
The minimum LPG cylinder capacity for this barbecue is 9 kg.
10
WWW.WEBER.COM
LPG CYLINDER INSTALLATION AND REMOVAL
Install the LPG Cylinder
A) Turn the LPG cylinder so the opening of the valve is to
the front of the Weber gas barbecue .
B) Lift and hook the LPG cylinder onto the extension
bracket on the cylinder scale (2) .
m WARNING: Make sure that the LPG
cylinder valve is closed. Close by turning
valve clockwise.
Connect the Regulator / Hose to the LPG Cylinder
The hose and regulator must be connected to the LPG
cylinder on the outside of the base cabinet, on the right
side of the barbecue .
A) Connect the hose and the regulator (3) to the LPG
cylinder .
m WARNING: No sealant is required on
the fitting. Do not use pipe dope, tape or
any other sealant on the fitting or LPG
cylinder.
B) Use your fingers to begin connecting the fitting to
the LPG cylinder valve . Turn nut clockwise until tight .
Position the regulator so that the vent hole faces down .
m WARNING: Do not use a spanner to
tighten the connection. Using a spanner
could damage the regulator coupling and
could cause a leak.
2
3