Dryer; Removing The Dryer Thermistor (Rt2), Air Vane Switch (S4), Dryer Heater (R2), And Dryer Blower Motor (B1) - Kodak X-Omat M43 PROCESSOR Service Manual

SERVICE MANUAL
Section 3: DRYER
Removing the DRYER THERMISTOR (RT2), AIR VANE
SWITCH (S4), DRYER HEATER (R2), and DRYER BLOWER
MOTOR (B1)
Important
Only qualified service personnel should service the PROCESSOR.
Important
All the procedures in this section require that you de-energize the PROCESSOR and remove the TOP COVER before
beginning the first step of the service procedure.
[1] Remove the NON-DRIVE SIDE ACCESS PANEL by loosening the 2 SCREWS.
[2] Remove:
• DRYER RACK
• WASH RACK
Removing the RACKS
Figure 31
[3] In order to remove dryer components, disconnect the CONNECTORS listed below. See Figure 32 on Page 39
for the location of the components.
DRYER COMPONENT
DRYER THERMISTOR
AIR VANE SWITCH
DRYER HEATER
DRYER BLOWER
DC INTERLOCK SWITCH S6
38
DRYER RACK
notch
WASH RACK
TAB
H130_0096ACA
H130_0096AA
CONNECTOR NUMBER
P/J19
P/J26
P/J4
P/J5
P/J28
September 1995 – 981090