Assembly - RIDGID R4021 Operator's Manual

ASSEMBLY

INSTALLING THE MITER GUIDE
See Figure 12.
 Align the grooves under the miter guide with the grooves
in the top of the rip guide.
 Push the miter guide onto the rip guide to the desired
operating position.
NOTE: Slide the guide off the rip guide to remove.
INSTALLING THE OVERFLOW DRAIN
See Figure 13.
 Firmly push the overflow drain into the hole in the bottom
of the water reservoir.
FILLING/CHANGING THE WATER RESERVOIR
See Figure 14.
The water reservoir must be filled at least to the MIN fill line
and should not be filled past the MAX fill line. Check the
water level periodically and refill as needed.
 Fill the water reservoir with clean tap water to the MAX
fill line.
NOTE: The overflow drain prevents overfilling.
To change reservoir water:
 Unplug the saw.
 Remove the overflow drain and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the machine thoroughly.
 Discard the waste water in accordance with local regula-
tions.
 Replace with clean water.
MITER
GUIDE
MAX FILL
MIN
FILL LINE
15 — English
LINE
Fig. 12
OVERFLOW
DRAIN
Fig. 13
WATER
RESERVOIR
Fig. 14