RIDGID R4021 Operator's Manual page 14

ASSEMBLY
INSTALLING THE SPLASH HOOD
See Figure 10.
 Remove the bevel table.
 Using a Phillips screwdriver, loosen and remove the three
screws located on the pocket under the table behind the
cutting wheel.
 Slide the L-shaped splash hood bracket into the pocket.
 Reinstall the screws through the splash hood bracket and
into the table. Tighten securely.
NOTE: Align the hood bracket with the cutting wheel so
that it does not interfere with the material being cut. To
check the alignment, see Splash Hood Bracket Adjust-
ment in the Adjustments section of this manual.
NOTE: Always adjust the splash hood horizontally to the
table and slightly above tile thickness. Hood should not
touch the tile.
 To lift or lower the splash hood or adjust its position,
loosen the lock knob, adjust the splash hood to the de-
sired height, and retighten the lock knob.
 Reinstall the bevel table.
INSTALLING THE RIP GUIDE
See Figure 11.
 Place the front of the rip guide on the front rail of the saw
table.
 Lower the back of the rip guide to the saw table.
 Use the rip guide scale, located on front of the table, to
set the rip guide to the desired width of cut.
 Push the locking lever down to secure to the saw table.
When securely locked, the locking lever should point
downward.
SPLASH
HOOD
LOCK
KNOB
RIP
GUIDE
14 — English
SPLASH HOOD
SCREWS
BRACKET
POCKET
Fig. 10
LOCKING
LEVER
Fig. 11