Setting Up Hardware
The USB-6008/6009 kit ships with signal labels. You can apply the signal labels to
Note
the screw terminal blocks for easy signal identification.
Note
Once you label the screw terminal blocks, you must only insert them into the
matching combicon jack, as indicated by the overlay label on the USB-6008/6009 device.
© National Instruments Corporation
Complete the following steps to set up the hardware:
1.
Install combicon screw terminal blocks by inserting them into the
combicon jacks.
2.
Refer to Table 2 and Figure 4 for label orientation and affix the
provided signal labels to the screw terminal blocks. Until the signal
labels are applied, you can insert the screw terminal blocks into either
of the combicon jacks. Refer to Figure 4 for more information about
signal label orientation.
2
3
1 Overlay Label with Pin Orientation Guides
2 Combicon Jack
Figure 4. Signal Label Application Diagram
3.
Connect the wiring to the appropriate screw terminals.
4
2
1
3 Signal Labels
4 USB Cable
7
USB-6008/6009 User Guide and Specifications
3