Table of Contents
Advertisement
Other Equipment
There are several required items not included in your device kit that you need to install or
operate the NI 5105.
•
(PXI Express Devices) A PXI Express chassis with a controller and the chassis
documentation
•
(PXI Devices) A PXI chassis, a PXI/SCXI combination chassis, or a PXI/CompactPCI
chassis with a controller and the chassis documentation
•
(PCI Devices) A desktop computer and its documentation
Note
If your application uses NI-TClk synchronization for PCI devices, you must
use a RTSI cable to connect the PCI devices. For more information, refer to NI
High-Speed Digitizers Help»Programming»Reference»NI-TClk
Synchronization Help.
Installing the Software
You must be an Administrator to install NI software on your computer.
1.
Install an ADE, such as LabVIEW or LabWindows
2.
Insert the driver software media into your computer. The installer should open
automatically.
If the installation window does not appear, navigate to the drive, double-click it, and
double-click
autorun.exe
3.
Follow the instructions in the installation prompts.
Note
installation. Accept the prompts to complete the installation.
4.
When the installer completes, select Restart in the dialog box that prompts you to restart,
shut down, or restart later.
Installing the Hardware
Installing the NI PXI/PXIe-5105
Caution
the device using the edges or the metal bracket.
1.
Ensure the AC power source is connected to the chassis before installing the modules.
The AC power cord grounds the chassis and protects it from electrical damage while you
install the modules.
2.
Power off the chassis.
3.
Inspect the slot pins on the chassis backplane for any bends or damage prior to
installation. Do not install a module if the backplane is damaged.
.
Windows users may see access and security messages during
To prevent damage to the device caused by ESD or contamination, handle
NI PXI/PXIe/PCI-5105 Getting Started Guide | © National Instruments | 5
™
™
/CVI
.
Advertisement
Table of Contents
