Break-Out Connectors; Starter Board To Interposer Board Interface Connectors - Samsung ARTIK 053s Hardware User's Manual

Samsung Semiconductor, Inc.
Table 8. Arduino Interface Connector Pin Descriptions (Continued)
Pin Number
10

Break-out Connectors

The two Break-out connector pinouts shown in Figure 8 are defined in Table 9. For each connector, the odd-
numbered row is closest to the edge of the board and is noted on the silkscreen.
Table 9. Break-out Connector Pin Descriptions
Odd-Numbered Connector Row
Break-out Connectors
CON703
XPWNTOUT_1 XPWNTOUT_4
XPWNTOUT_2 XPWNTOUT_2
XPWNTOUT_3
XPWNTOUT_0
XUART1_RXD
XUART1_TXD
XGPIO26
XGPIO25
XGPIO24
XGPIO23
XGPIO22
XEINT0

Starter Board to Interposer Board Interface Connectors

The Starter board interfaces to the Interposer board via two 50-pin Hirose connectors. For more information on the
pinout of these connectors, refer to the section above entitled ARTIK O53s Interposer Board Connectors.
CON708
XI2C0_SCL
Connector Pin
Number
CON704
1
3
XEINT2 5
XEINT1 7
XGPIO12 9
XGPIO10 11
XGPIO9 13
XGPIO11 15
XGPIO8 17
XGPIO2 19
XGPIO1 21
XGPIO3 23
ARTIK 053s Development Kit Hardware User's Guide
Arduino Connectors
CON709 CON710
—
Even-Numbered Connector Row
Connector Pin
Number
2
4
6
8
10
12
14
16
18
20
22
24
CON711
— —
Break-out Connectors
CON703 CON704
VDD_EXT3P3 VDD_EXT3P3
N/C XUART2_RXD
N/C XUART2_TXD
XI2C1_SCL XUART3_RXD
Xi2C1_SDA XUART3_TXD
GND
VCC_EXT3P3 VCC_EXT3P3
XSPI0_CLK XGPIO4
XSPI0_CS XGPIO5
XSPI0_MISO XGPIO6
XSPI0_MOSI XGPIO7
GND
GND
GND
13