Table of Contents
Advertisement
Samsung Semiconductor, Inc.
Table 3. ARTIK 053s Interposer Board CON401 Connector Pinout and ARTIK Module Pin Mapping (Continued)
ARTIK Module
Pin Name
Pin Number
N/A
N/A
N/A
N/A
N/A
N/A
EXT_5V_12V
32
ARTIK 053
S
S
TARTER
The ARTIK 053s Development Kits includes a Starter Board which connects to the Interposer board. This section is
divided into interface types and connector types on the Starter board.
Starter Board Interfaces
This section describes the various interfaces on the Starter board.
Power Interface
Power to the ARTIK 053s Starter Kit can be sourced from the micro-USB connector, a 5 - 12V DC Jack, or a 5.6 - 6.4V
battery. Table 4 shows the jumper settings to select each of the power sources. Note that pins 1 - 2 are located
closest to the edge of the board.
Table 4. Power Configuration Jumper Settings
CON705 Power Jumper
Connections
1 - 2
3 - 4
5 - 6
Connector CON400
Pin Name
Pin Number Pin Number
N/C
37
N/C
39
N/C
41
DC_5V_12V
43
DC_5V_12V
45
DC_5V_12V
47
DC_5V_12V
49
B
OARD
Power Source
micro-USB (CON700)
Power is applied by the micro-USB connector. The pinout of the
USB connector is as follows:
Pin 1: VCC_USBP0 power
Pin 2: D-
Pin 3: D+
Pin 4: NC
Pins 5 - 11: Ground
DC Jack (CON712)
Power is supplied by the DC power jack. The pinout of the DC jack
is as follows:
Pin 1: 5V - 12V DC power
Pin 2: Ground
Pin 3: Ground
2-pin header (CON706)
Power is supplied by a battery connected to CON706 as shown
below. The pinout of the battery connector is as follows:
Pin 1: 5V - 12V external battery power
Pin 2: Ground
Pin 1 of the battery connector is not identified on the silkscreen but
rather by the square pad on the bottom of the Starter board. Pin 1 is
also shown in Figure 4.
ARTIK 053s Development Kit Hardware User's Guide
Pin Name
Pin Number
38
XPWM4_OUT
40
N/C
42
GND
44
GND
46
GND
48
GND
50
GND
Description
ARTIK Module
Pin Name
40
XPWMTOUT_4
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
8
Hide quick links:
Advertisement
Table of Contents
