Table of Contents
Advertisement
Comfort
POWER HEAD RESTRAINTS*
You can press the button on the overhead console to fold the
third-row outermost head restraints.
POWER SEATS*
You can adjust your seat in a variety of ways to help find the
best fit for you. The seat controls are on the side of the seat.
Using these controls, you can adjust seat height, recline, lumbar
support,* and the head restraint.* See the Power Seats chapter in
your Owner's Manual for more information.
POWER FOLDING SECOND-ROW BENCH SEATS*
The control for the power folding second-row bench seats is
located on the quarter trim panel.
Press the top button to fold the left seatback.
Press the middle button to fold the middle seatback.
Press the bottom button to fold the right seatback.
To return the seatback to the original position, rotate the seatback
up until the seatback latches in the upright position. The seatback
clicks when it is locked into position.
16
(co n t in u ed )
POWER FOLDING THIRD-ROW SEAT*
The 60/40 split-folding bench seat uses a power-activated
seatback release. Fold one side or both down for more flexibility.
The controls are on the left-hand rear quarter trim panel,
accessible from the liftgate area.
Note:
Make sure you unfasten all of the seatbelts and fold the head
restraints down first.
To lower
1. Press the corresponding control(s) or use the middle control to
fold both seats down.
2. To return the seatback(s) to the original position(s), press the
corresponding control(s) again.
See the Seats chapter in your Owner's Manual for
more information.
Note:
The power folding seats operate for 10 minutes after you
switch the ignition off. The transmission must be in park (P) and the
liftgate or liftgate glass must be open.
POWER RECLINE
The third-row power recline buttons are on the quarter trim panel
on each side of the vehicle.
*
if equipped
MOONROOF*
The moonroof control is on the overhead console. It has a
one-touch open and close feature. To stop its motion during the
one-touch operation, press the control a second time.
To open the moonroof, press and release
. The moonroof stops
short of the fully opened position. To open the moonroof fully,
press and release the control again. To close the moonroof, press
and release
.
To vent the moonroof, press and release
.
The sunshade automatically opens with the moonroof. You can
also open the sunshade with the moonroof closed. To open the
sunshade, press and release
. The sunshade stops short of its
fully opened position for the comfort of rear passengers. To open
the sunshade fully, press the control again.
To close the sunshade, press and release
. The sunshade does
not fully close unless the moonroof glass is fully closed.
DRIVER ALERT
The system automatically monitors your driving behavior using
various inputs including the front camera sensor. If the system
detects that your driving alertness is reduced below a certain
threshold, the system will alert you using a chime and a message
in the information display. Switch the system on or off using the
information display.
*
if equipped
BLIS
(BLIND SPOT INFORMATION SYSTEM)
®
AND CROSS TRAFFIC ALERT*
This system is designed to aid you in detecting vehicles that may
have entered the detection area zone. The detection area is on
both sides of your vehicle and trailer, extending rearward from the
exterior mirrors to the end of your trailer. Cross traffic alert warns
you of vehicles approaching from the sides when the transmission
is in reverse(R).
When a trailer is attached and you have set up a Blind Spot Trailer,
the system becomes active when driving forward above 6 mph
(10 km/h). Refer to the Driving Aids chapter in your Owner's Manual
for more information.
Note:
NEVER use BLIS or cross traffic alert as a replacement for
using the interior and exterior mirrors and looking over your shoulder
before changing lanes. The systems are not replacements for careful
driving. Use both systems only as an assist.
17
Advertisement
Table of Contents
