Table of Contents
Advertisement
Advanced Features
In the Advanced Features page within Configuration, an administrator can do the
following things:
•
Set the SME 211 to run a web browser client application for direct control using
USB keyboard and mouse for network (IP) configuration when a network-connected
computer is not available.
•
Upload a FlexOS plugin application to add functions and configuration options, then use
the plugin to configure features of the SME.
These settings are available only via this page.
To open this page, click the Configuration tab (at the top of the SME 211 embedded
web pages) and then click the Advanced Features tab on the second tier of tabs.
The Advanced Features page opens, showing the Browser Client (
Apps (
) panels.
2
1
2
Figure 34.
Control the SME 211 Using an Internal Browser Client
The SME 211 can be configured to run a web browser client application for direct control
if a standalone computer is not available on site. If enabled, the internal browser provides
access to a subset of the Network (IP) Settings configuration panel.
NOTE: The internal browser client is enabled by default. If it has been disabled, it is
necessary to use the config port to recover or reset the device IP address to reach the
internal web pages.
To set up the SME 211 for local control using its internal browser client:
NOTE: The following steps do not require a computer and do not require the SME to be
connected to a network.
1.
Connect a monitor and a keyboard and mouse directly to the SME 211 (see
System and External Device Connections
Connect the keyboard to either the front or the rear USB port.
•
Connect the mouse to the other (rear or front) USB port.
•
Connect a display to the local HDMI Out port on the rear panel.
•
2.
By default, the local output shows the preview (streaming) image on the connected
monitor or display. To switch between viewing the preview and viewing the network
configuration page, press <Ctrl+Alt+S> on the keyboard connected to the SME.
NOTE: The default web page allows configuration of the network settings.
3.
Use the mouse and keyboard to navigate in the network configuration page and make
changes as needed.
4.
When all the changes have been completed, press the <Ctrl+Alt+S> keys on the
3
Advanced Features Page
on page 9).
SME 211 • Web-Based User Interface
) and FlexOS
1
Control
48
Advertisement
Table of Contents
