Yamaha VMX12 2001 Service Manual page 170

CLUTCH
2. Install:
• clutch boss assembly 1
NOTE:
@
• If the wire circlip 2 has been removed, care-
fully install a new one as shown.
• Install the clutch spring plate 3 with the
"OUTSIDE" mark facing out.
@
3. Install:
• clutch boss 1
• lock washer
• clutch boss nut 2
NOTE:
@
While holding the clutch boss with the univer-
sal clutch holder 3, tighten the clutch boss
nut.
@
Clutch holding tool
90890-04086
4. Bend the lock washer tab along a flat side of
the nut.
5. Lubricate:
• long clutch push rod 1
• ball 2
• short clutch push rod 3
(with the recommended lubricant)
Recommended lubricant
Lithium soap base grease
6. Install:
• long clutch push rod
• ball
• short clutch push rod
(along with the O-ring 4)
NOTE:
@
Insert the rounded end of the long clutch push
rod into the clutch boss first.
@
4 - 40
ENG
New
70 Nm (7.0 m · kg)