Yamaha VMX12 2001 Service Manual page 16

EAS00027
SPECIAL TOOLS
The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
90890-01122
90890-01196
90890-01229
90890-01230
90890-01304
90890-01312
Tester
90890-01325
Adapter
90890-01352
Tool name/Function
Valve guide remover (5.5 mm)
This tool is needed to remove and
install the valve guide.
Valve guide reamer (5.5 mm)
This tool is needed to rebore the new
valve guide.
Coupling gear/middle shaft tool
This tool is needed when removing or
installing the coupling gear nut.
Final gear backlash band
This tool is needed when measuring
final gear backlash.
Piston pin puller set
This tool is used to remove the piston
pin.
Fuel level gauge
This gauge is used to measure the fuel
level in the float chamber.
Radiator cap tester
Adapter
This tester and its adapter are needed
for checking the cooling system.
SPECIAL TOOLS
1 - 5
GEN
INFO
Illustration