ABB ACSM1 Firmware Manual page 148

148
48.05 R BR
Defines the resistance value of the brake resistor. The value is used for brake chopper protection.
0.1...1000 ohm
48.06 BR TEMP FAULTLIM
Selects the fault limit for the brake resistor temperature supervision. The value is given in percent of
the temperature the resistor reaches when loaded with the power defined by parameter
POWER MAX
When the limit is exceeded the drive trips on fault BR OVERHEAT.
0...150%
48.07 BR TEMP ALARMLIM
Selects the alarm limit for the brake resistor temperature supervision. The value is given in percent of
the temperature the resistor reaches when loaded with the power defined by parameter
POWER MAX
When limit is exceeded the drive generates alarm BR OVERHEAT.
0...150%
Parameters and firmware blocks
FW block:
Resistance.
FW block:
CNT.
Resistor temperature fault limit.
FW block:
CNT.
Resistor temperature alarm limit.
BRAKE CHOPPER (see above)
BRAKE CHOPPER (see above)
BRAKE CHOPPER (see above)
48.04 BR
48.04 BR