Control Panel - Riello AMD 35 PA Installation And Technical Service Instructions

INStAllAtION

2.15 Control panel

Control, setting and programming operations are carried out
with the wired control panel.
The electronics modulates the device operation according to the
temperatures detected by the probes inside the indoor and out-
door units.
For correct installation, remember that the panel:
— Must be installed on a wall, preferably not a perimeter
one, and one without any hot or cold pipes inside.
— It must be mounted at 1.5 m from the floor.
— It must not be placed next to doors or windows, cook-
ing devices, radiators, fan coils or, more generally, it must
not be places in conditions that might alter the measured
temperatures.
— The maximum length of the connecting cable must be tak-
en into account.
— Use a shielded cable for the connection.
— The connection cable must not be spliced; if splicing is
necessary, it shall be tinned and adequately protected.
— Any trenching of the connection cable must be separated
from the live wires.
OK
Placement
Connection
NO
NO
1
2
3
18
— separate the control panel from the base
— press the upper bottom (1) to remove the base from the
control panel
— mark the fastening points using the base as a template.
— drill a hole in the wall
— drill a hole in the wall, through which the connections
shall be threaded
— thread the connection cable of the control panel through
the hole in the base
— anchor the base with appropriate screws and bolts
— connect the cable to the clamps on the control panel, pay-
ing attention to polarity
— remount the control panel on the base.
1
3
Unit
Polarized connector
Control panel
1
C B A
3
C
2
B
A
CON1
2
1